Image Name: MIPS Open Wrt Linux-3.18.23 Created: 2016-03-03 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: 1136063 Bytes = 1.1 MB Load Address: 80060000 Entry Point: 80060000 Verifying Checksum at 0x9f050040 ... [ 0.000000] Primary data cache 32k B, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on.

Total pages: 8128 [ 0.000000] Kernel command line: board=UBNT-AGW console=tty S0,115200 mtdparts=spi0.6k(u-boot)ro,64k(u-boot-env)ro,7552k(firmware),256k(cfg)ro,64k(EEPROM)ro rootfstype=squashfs,jffs2 noinitrd [ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes) [ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Writing Err Ctl register=00000000 [ 0.000000] Readback Err Ctl register=00000000 [ 0.000000] Memory: 28456K/32768K available (2477K kernel code, 126K rwdata, 528K rodata, 252K init, 188K bss, 4312K reserved) [ 0.000000] SLUB: HWalign=32, Order=0-3, Min Objects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:51 [ 0.000000] Clocks: CPU:387.500MHz, DDR:387.500MHz, AHB:193.750MHz, Ref:25.000MHz [ 0.000000] Calibrating delay loop...

Having said that, I just switched to Open Wrt, and love it!

updating openwrt firmware-55

Chat with over 50 females adult chat - Updating openwrt firmware

Most of this article has to do with my use of that first router.

I played with the original WRT54G with DDWRT for a maximum of 15 minutes, then flashed Tomato to the drive, then imposed access controls. It was faster than the WRT54G Tomato router I have at home.

Both DD-WRT and Open Wrt have free software licences, and even share some of the same code.

The major difference between the two is the approach to building a working system: Just to reassure you that it doesn’t require tons of effort: when I first booted Open Wrt it had everything I needed to get connected to my modem, use wifi, a nice web interface etc.

So what is Open Wrt and why did I even try it if DD-WRT is so good?

Open Wrt, like DD-WRT, is a free (libre) GNU/Linux distribution for routers.

There are about 3500 optional software packages available for installation via the opkg package management system.

Open Wrt can run on various types of devices, including CPE routers, residential gateways, smartphones, pocket computers (e.g. It is also possible to run Open Wrt on personal computers, which are most commonly based on the x86 architecture.

which in turn enabled independent developers to create additional derivative versions.

Support was originally limited to the WRT54G series, but has since been expanded to include many other chipsets, manufacturers and device types, including Plug Computers and Openmoko mobile phones.

258.04 Bogo MIPS (lpj=1290240) [ 0.070000] pid_max: default: 32768 minimum: 301 [ 0.070000] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.080000] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.090000] NET: Registered protocol family 16 [ 0.090000] MIPS: machine is Ubiquiti Air Gateway [ 0.550000] Switched to clocksource MIPS [ 0.550000] NET: Registered protocol family 2 [ 0.560000] TCP established hash table entries: 1024 (order: 0, 4096 bytes) [ 0.560000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) [ 0.560000] TCP: Hash tables configured (established 1024 bind 1024) [ 0.570000] TCP: reno registered [ 0.570000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.580000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.590000] NET: Registered protocol family 1 [ 0.590000] futex hash table entries: 256 (order: -1, 3072 bytes) [ 0.620000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.620000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.